Cromar Flashing Tape 600mm x 10m

Preparation:
Surfaces must be clean and free from dust, grease, loose materials and ponding water. Gaps greater than
3mm should be filled using an appropriate filler. For adhesion on porous or uneven surfaces, the use of a
primer is advised at a rate of 1.8m² per litre and allowed to dry. Do not leave the primer for more than 24
hours and therefore only coat an area enough for covering within the day. Some surfaces may require a
second coat of primer which should be applied once the first coat is dry.
Application:
Cut the Flashing Strip to the length required. To avoid any creasing remove approximately 50mm of backing
paper and carefully position the sealing strip, hold the backing paper firmly and remove it steadily from the
sealing strip as the product is applied. Smooth into position using hand pressure. Using a seam roller or
rounded wood smooth to ensure good contact and expel any air, especially on overlaps and at the edges.
When laying adjacent rolls Flashing Strip should be overlapped by a minimum of 25mm for a watertight seal.
The seam must be pressed firmly with a hand roller paying particular attention at the point of overlap.
In cold weather (5-15oC), application will be made easier by warming the surfaces and storing the Flashing
Strip in a warm place prior to use.